Installation Of The Product - Husqvarna AUTOMOWER 520H Operator's Manual

D
B
®
3.4.6 Automower Club Solution
®
Automower Club Solution makes it possible to use 2 or
3 products in one installation. It requires special
configuration in the product and the installation of the
boundary wires and charging stations is different. To use
®
Automower Club Solution, speak to your local
Husqvarna representative.
The installation of the boundary wire and charging
stations must be made in parallel. The recommended
distance (A) between the charging stations is 5 m / 16 ft.
Maximum width of the work area is 70 m / 230 ft.
1457 - 005 - 16.10.2020
A
The changes when using the Automower
configuration are:
• The product will find the charging station with the
charging station signal or follow the boundary wire
clockwise.
• You cannot use guide cables.
• You cannot use the Park button.
• The cutting disc speed and noise level increases.
C

3.5 Installation of the product

3.5.1 Installation tools
• Hammer/plastic mallet: To simplify putting the
stakes into the ground.
• Edge cutter/straight spade: To bury the boundary
wire.
• Combination pliers: For cutting the boundary wire
and pressing the connectors together.
• Adjustable plier: For pressing the couplers
together.
3.5.2 To install the charging station
A
A
A
WARNING:
Obey national regulations
about electrical safety.
WARNING:
The product is only to be
used with the power supply unit supplied by
Husqvarna.
WARNING:
Do not put the power
supply at a height where there is a risk it can
be put in water. Do not put the power supply
on the ground.
WARNING:
Do not encapsulate the
power supply. Condensed water can harm
the power supply and increase the risk of
electrical shock.
®
Club Solution
Installation - 19