Table of Contents
Advertisement
To set the reversing distance
1.
Select
Settings > Installation > Reversing distance
in the app.
2.
Move the horizontal bar to set the distance.
Save .
3.
Select
3.11.3.6 Drive Past Wire
The front of the product always moves past the
boundary wire by a specified distance before the product
moves back into the work area. The factory setting for
the
Drive Past Wire function function is 37 cm / 15 in.
You can select a distance of 20-50 cm / 8-19 in.
Note:
With the factory setting the product will cut 11
cm / 4 in. past the wire.
Note:
Drive Past Wire distance is changed, the
If the
distance will change along the boundary wire
everywhere in the work area.
To set the Drive past wire
Settings > Installation > Drive past wire in
1.
Select
the app.
2.
Move the horizontal bar to set the distance.
3.
Select
Save .
3.11.4 Accessories
Settings for accessories mounted on the product can be
made in this menu.
3.11.4.1 To avoid collisions with the mower house
When this option is enabled, the wear on the product
and the house is reduced, but it can result in more uncut
grass around the charging station.
Settings > Installation > Mower house in the
1.
Select
app.
on/off to enable or disable the function.
2.
Select
3.
Select
Save .
3.11.4.2 To set the ultrasonic
Settings > Installation >Ultrasonic in the
1.
Select
app.
on/off to enable or disable the function.
2.
Select
3.
Select
Save .
28 - Installation
3.11.5 General (Bluetooth
This function is used to set time and date, or to reset to
default settings.
3.11.5.1 Time & date
The time and date can be changed manually, or by
using the time and date from the mobile device.
To set the time & date
Settings > General > Time & Date in the
1.
Select
app.
Time & Date from phone or select the pencil
2.
Select
to enter the correct time and date.
Save .
3.
Select
3.11.5.2 Reset to factory settings
The user settings can be reset to factory settings.
Note:
PIN code, Loop signal, Messages and Date &
Time will not be reset.
To reset to factory settings
Settings > General > Reset in the app.
1.
Select
2.
Select
Reset to factory settings .
3.11.6 Security (Bluetooth
The security settings controls the PIN code, the
GeoFence and other security functions. The correct PIN-
code must be entered to get access to the
®
menu in the Automower
Connect app.
3.11.6.1 New loop signal
The loop signal is randomly selected to create a unique
link between the product and the charging station. In
rare cases, there may be a need to generate a new
signal, for instance if 2 adjacent installations have a very
similar signal.
To create a New loop signal
1.
Put the product in the charging station.
Security > New loop signal > Create new
2.
Select
loop signal in the app.
3.
Select
Save .
4.
Wait for confirmation that the loop signal has been
generated. This usually takes about 10 seconds.
®
only)
®
only)
Security
1457 - 005 - 16.10.2020
Advertisement
Table of Contents
