Table of Contents
Advertisement
The factory setting is set to use the 3 search methods at
the same time. Use the factory setting to find the
charging station as fast as possible and to keep the risk
of tracks on the lawn to a minimum. The product always
Charging station signal . After a
starts to search for the
specified time interval, it also uses
Follow boundary wire .
Causes why the product cannot follow the wire:
•
Obstacles near the wire have not been isolated.
•
The charging station, the boundary wire or the
guide wire are not installed according to the
To install the charging station on
instructions in
page 19 , To install the boundary wire on page 20
To install the guide wire on page 21 .
and in
To change the signal range of the charging station
For some installations it is necessary to decrease the
signal of the charging station. For example when the
charging station is put near an obstacle such as a bush
or wall and the signal reaches to the other side of the
obstacle. The product knows that it is close to the
charging station and tries to dock, but the objects
min , avg (average) or max .
prevents it. The options are
Note:
The recommended setting is
better to move the charging station, than to decrease the
range of the charging station signal.
Settings > Installation > Find charging
1.
Select
station in the app.
2.
Select signal range.
Save .
3.
Select
To set the delay time for the guide wire and the
boundary wire
Settings > Installation > Find charging
1.
Select
station in the app.
2.
Select
on/off to enable or disable to follow the wire.
3.
Move the horizontal bar to set the time delay.
Save .
4.
Select
3.11.3.2 Lawn coverage
The product has GPS Assisted Navigation that helps the
product select the most optimal operation.
Lawn coverage function to set the settings to
Use the
manual.
To set the GPS function
Installation > Settings > Lawn coverage in
1.
Select
the app.
2.
Select
on/off to disable or enable the GPS
function.
Note:
When GPS assisted navigation is enabled
it is used while there is a GPS service. The GPS
assisted navigation is used even if manual settings
26 - Installation
3.
To set the Lawn Coverage function
Follow guide and
The
product to remote parts of the work area. If the work
area includes remote parts that are connected with
narrow passages, the
to to keep a well-cut lawn in all parts of the yard. You
can set a maximum of 5 remote areas where the product
starts to cut the lawn.
With the
follows and then leaves the guide wire after a certain
distance and starts to mow the lawn.
Area A, approximately 50%
Area B, approximately 30%
Area C, approximately 20%
max . It is usually
Each area can be enabled or disabled, without having to
enter the settings again.
1.
2.
3.
4.
5.
6.
have been made. Only when GPS service is not
available, the manual settings are used.
Save .
Select
Lawn Coverage function is used to guide the
Lawn Coverage function is useful
Lawn Coverage function the product first
A
Settings > Installation > Lawn coverage in
Select
the app.
on/off to disable the GPS function to set the
Select
Lawn Coverage .
Area 1-5 to activate the area.
Select on/off
Move the horizontal bar to set which wire the
product will follow. The product can follow
Boundary wire left , Boundary wire right or one of
the guide wires.
Move the horizontal bar to set the distance the
product must follow the wire. The product then
leaves the wire and starts to cut the lawn. Refer to
To measure the distance from the charging station
on page 27 .
Move the horizontal bar to set how often the
product goes to each area. At all other times, the
products starts to cut near the charging station.
1457 - 005 - 16.10.2020
C
B
Advertisement
Table of Contents
