Table of Contents
Advertisement
3.8 To extend the boundary wire or the
guide wire
Note:
Extend the boundary wire or the guide wire if it
is too short for the work area. Use original spare parts,
for example couplers.
1.
Disconnect the charging station from the power
outlet.
2.
Cut the boundary wire or the guide wire with a pair
of wire cutters where it is necessary to install the
extension.
3.
Add wire where it is necessary to install the
extension.
4.
Put the boundary wire or the guide wire into
position.
5.
Put the wire ends into a coupler.
Note:
Make sure that you can see the ends of
the boundary wire or the guide wire through the
transparent area of the coupler.
6.
Push down the cover on the coupler with
adjustable pliers to attach the wires in the coupler.
7.
Put the boundary wire or the guide wire into
position with stakes.
8.
Connect the charging station to the power outlet.
3.9 After the installation of the product
3.9.1 To do a visual check of the charging
station
1.
Make sure that the indicator LED lamp on the
charging station has a green light.
2.
If the indicator LED lamp does not have a green
light, do a check of the installation. Refer to
indicator lamp on the charging station on page 43
and
To install the charging station on page 19 .
3.9.2 To do the basic settings
When the product is switched on for the first time, there
are some basic settings to do before the product can
22 - Installation
start to operate. You must for example pair the product
and the charging station, and you can choose to enable
the theft protection in GeoFence. Refer to
page 29 . You must also pair the product and the
®
Automower
Connect app to be able to change the
settings and operate the product. Refer to
Connect on page 22 .
1.
Switch on the product.
Note:
The Bluetooth
for 3 minutes. If pairing has not been successful
within this time period, switch off the product.
Wait until the LED status indicator is not lit, and
then switch on the product again.
2.
Enter the factory PIN code.
3.
Log in to your Husqvarna account in the
®
Automower
4.
Start Bluetooth
My mowers in the Automower
5.
Select
app, and then select the plus sign (+).
6.
Select model. The Automower
searches for available products within short-range
®
(Bluetooth
7.
Select product.
8.
Obey the instructions in the Automower
app.
Note:
It is only necessary to pair the Automower
Connect app and the product once.
Note:
To disconnect the Automower
the app must be fully closed down.
3.10 Automower
The app gives 2 modes of connectivity: Long-range
cellular connectivity and Short-range Bluetooth
connectivity.
The product can connect to mobile devices that have the
®
Automower
Connect app installed. Automower
Connect is a free app for your mobile device. The
®
Automower
Connect app gives extended functions to
your Husqvarna product. You can:
•
See the status of your product.
•
Change settings to your product.
•
Get extended product information.
•
Get an alarm if the product moves out of the work
LED
area.
•
See statistics of your product.
GeoFence on
Automower
®
pairing mode is active
Connect app.
®
on your mobile device.
®
Connect
®
Connect app
).
®
®
Connect app,
®
Connect
1457 - 005 - 16.10.2020
®
Connect
®
®
®
Advertisement
Table of Contents
