Table of Contents
Advertisement
•
Put the charging station in an area with protection
from the sun.
•
If the charging station is installed on an island,
make sure to connect the guide wire to the island.
To make an island on page 17 .
Refer to
3.4.2 To examine where to put the power
supply
WARNING:
low-voltage cable. There is a risk of
electrical shock.
CAUTION:
Make sure that the blades
on the product do not cut the low-voltage
cable.
CAUTION:
Do not put the low-voltage
cable in a coil or below the charging station
plate. The coil causes interference with the
signal from the charging station.
•
Put the power supply in an area with a roof and
protection from the sun and rain.
•
Put the power supply in an area with good airflow.
•
Use a residual-current device (RCD) when you
connect the power supply to the power outlet.
Low-voltage cables of different lengths are available as
accessories.
3.4.3 To examine where to put the
boundary wire
CAUTION:
There must be an obstacle
of minimum 15 cm / 6 in. in height between
the boundary wire and water bodies, slopes,
1457 - 005 - 16.10.2020
Do not cut or extend the
precipices or public roads. This will prevent
damage to the product.
CAUTION:
Do not let the product
operate on gravel.
CAUTION:
Do not make sharp bends
when you install the boundary wire.
CAUTION:
For careful operation
without noise, isolate all obstacles such as
trees, roots and stones.
The boundary wire should be put as a loop around the
work area. Sensors in the product senses when the
product approaches the boundary wire, and the product
selects another direction. All parts of the work area must
be maximum 35 m / 115 ft. from the boundary wire.
To make the connection easier between the guide wire
and the boundary wire, it is recommended to make an
eyelet where the guide wire will be connected. Make the
eyelet with approximately 20 cm / 8 in. of the boundary
wire.
CAUTION:
Make a blueprint of the work
area before you install the boundary wire
and guide wire.
Installation - 15
Advertisement
Table of Contents
