Table of Contents
Advertisement
O
I
PERATING
NSTRUCTIONS
U
T
T863 T
SING
HE
RANSMITTER
F
. 4: T863 T
IG
RANSMITTER
"On" Indicator LED
Microphone Jack
T863 Top
T863 Front
12
V
IEWS
On/Off/Channel
Selector Switch
Antenna
Note: Rechargeable batteries are shipped in a discharged
state and must be charged overnight before using.
1. Make sure there are two charged AA batteries in the transmit-
ter. If batteries are not installed, see Battery Information on
page 19.
2. Plug the microphone cord into the "Microphone Jack" on top
of the transmitter.
3. Turn the unit on: turn the On/Off/Channel switch to position
"1" or "2" or "3." The Power "ON" LED indicator should illu-
minate Red.
4. Select a desired operating frequency. To operate on 863.25
MHz, turn the On/Off/Channel switch to position "1"; to oper-
ate on 863.75 MHz, turn to position "2"; to operate on 864.75
MHz, turn to position "3."
Important: The receiver will need to match the operating
frequency on the transmitter for the tour guide system to
work properly.
5. Position the Headset Microphone boom as close to the speak-
er's mouth as possible without actually touching. Lapel Clip
microphones should be attached to a collar or lapel, as close
to the speaker's mouth as possible.
The transmitter can be placed in a pocket, or clipped onto a
belt or waistband.
IMPORTANT: When the T863 transmitter is not being used,
remember to turn the unit OFF by turning the
On/Off/Channel switch to the " " power icon position. The
Power "ON" LED indicator should not be lit.
13
Advertisement
Table of Contents
