Belt Clip - Williams Sound TGS 863 Manual And User Manual

U T R863 R ,
Rechargeable batteries are shipped in a discharged
SING HE ECEIVER
state and must be charged overnight before using.
Note:
1. Make sure there are two alkaline or rechargeable AA batteries
in the Receiver. If batteries are not installed, see Battery
Information on page 19.
2. Plug the earphone or headphone into the "
of the Receiver. For earphone/headphone options, see pages 8-9.
3. Put on the earphone or place the headphones over your ears.
4. Turn the unit on: turn the On/Off/Channel switch to position
"1" or "2" or "3." The Power "ON" LED indicator should illu-
minate Red.
5. Select a desired operating frequency. To operate on 863.25
MHz, turn the On/Off/Channel switch to position "1"; to oper-
ate on 863.75 MHz, turn to position "2"; to operate on 864.75
MHz, turn to position "3."
Important: Make sure the receiver is operating on the same
frequency as the transmitter! The receiver's channel switch
(1-2-3 position) should match the transmitter's channel switch.
6. Adjust the receiver volume control to a comfortable listening level.
You should be able to hear someone speaking into the trans-
mitter microphone.
The receiver can be placed in a pocket, or clipped onto a belt,
harness, or waistband.
IMPORTANT: When the R863 receiver is not being used,
remember to turn the unit OFF by turning the
On/Off/Channel switch to the "
Power "ON" LED indicator should not be lit.
16
.
CONT
" Jack on top
" power icon position. The
B C I
ELT LIP NSTALLATION FOR THE
Position the belt clip on the rear of the R863 receiver or T863
T I :
O NSTALL
transmitter as shown in FIG. 7A. Turn the belt clip 180º left or
right as shown in FIG. 7B. The belt clip is now installed and
ready for use.
Turn the belt clip 180º so the open end of the clip points to the
T R :
O EMOVE
top of the unit as shown in FIG. 7A. Gently pull the belt clip
away from the unit to remove.
F . 7
IG A
TGS 863 S
YSTEM
F . 7
IG B
17