Advertisement
5 Highlight your firearm sensor device and press Connect.
NOTICE:
Activation code must be sent to the device by third-party application.
Radio-initiated automatic reconnection with several remote Bluetooth devices at the
same time cannot be guaranteed to be successful in 100%, due to the fundamental
nature of Bluetooth. In case the reconnection fails after a power cycle (power off and
power on of the radio), reconnect the device manually.
The radio is now able to notify the dispatcher when the status of the firearm device changes. If
configured, the location (using GPS) of the radio is reported as well. Once a firearm sensor
device is connected, it can be managed from the Devices menu.
6 Highlight your firearm sensor device and press Menu/OK to connect.
NOTICE:
Activation code must be sent to the device by third-party application.
Radio-initiated automatic reconnection with several remote Bluetooth devices at the
same time cannot be guaranteed to be successful in 100%, due to the fundamental
nature of Bluetooth. In case the reconnection fails after a power cycle (power off and
power on of the radio), reconnect the device manually.
The radio is now able to notify the dispatcher when the status of the firearm device changes. If
configured, the location (using GNSS) of the radio is reported as well. Once a firearm sensor
device is connected, it can be managed from the Devices menu.
7 To disconnect a firearm sensor device, go to the Devices menu and follow the normal device
management procedure.
4.9
Man Down
NOTICE: This is a Software Selling Feature.
Man Down alerts when no movement occurs for a set time or the radio stays at an angle of tilt below a
defined value. The radio alerts you when:
•
Its tilt exceeds a predefined angle value.
•
No movement is detected in a predefined time interval.
In case any of the conditions are met, the radio alerts you with a Man Down pre-alert. If you do not
disable the pre-alert condition, the radio switches to the Emergency Operation.
For easier localization of the radio, visual and audible indications are started until they are deactivated.
If the Emergency Hot Microphone is on, the additional audio indication is not played.
To exit Man Down, exit the Emergency Mode by pressing and holding the Exit Soft key, or press the
PTT button.
4.9.1
Setting Man Down
Procedure:
1 From the home screen, press the Menu key.
2 From the home screen, press the Menu/OK key.
3 Select Man Down.
MN004519A01-AK
Chapter 4: Main Menu
97
Advertisement
