Start Screen; Drive Status - Baumuller b maXX 3000 Instruction Handbook Manual

7.4
Basic menus

7.4.3.4 Start screen

This sub-menu sets the screen displayed after switching on the Control Panel.

7.4.3.5 Drive status

This sub-menu sets the parameter displayed in menu
Up to 19 parameters can be configured, the first parameter displayed is always parameter
Error Information P100.003, if an error message exists.
Following parameters are preset:
This parameter will be displayed again, if the Control Panel is reset to delivery status,
see
The sub-menu shows a list of 19 parameters with corresponding check box.
46
Instruction handbook Control Panel BM3000/BM5000
Document No. 5.12068.01
of 68
A1
3.5.1
Start Screen
Predefined Parameter List
Load From Controller
<< >>
ΟΚ
↑
Parameter ID
P 100.003.0.0
P 108.001.0.0
P 108.003.0.0
P 108.007.0.0
P 108.008.0.0
P 109.002.0.0
P 108.016.0.0
P 131.015.0.0
P 156.002.0.0
P 018.022.0.0
P 128.003.0.0
ZReset Control Panel–
h Select with << (T2) and >> (T3),
with OK (T4)
Following choices are possible
n Predefined Parameter List
n Load From Controller
n Save To Controller
n Firmware versions
n Drive Status
n none
Parameter name
Error info, if at least one error message is generated
Control word 1
Status word 1
Communication source
Status dig. inputs drive manager
Actual operation mode
Status internal limits
Actual IP address
Synchronization status
Speed actual value
Motor temperature
on page 52.
„Drive Status".
Baumüller Nürnberg GmbH