Section 1: Safety Rules & General Information; Introduction; Read This Manual Thoroughly; Safety Rules - Generac Power Systems Protector Series Installation Manuallines

Spark-ignited stationary generators
Hide thumbs Also See for Protector Series:
Table of Contents

Advertisement

Section 1: Safety Rules & General Information

Introduction

Thank you for purchasing this compact, high perfor-
mance, liquid-cooled, engine-driven generator. It is
designed to automatically supply electrical power to oper-
ate critical loads during a utility power failure.
This unit is factory installed in an all-weather enclosure
intended exclusively for outdoor installation. This genera-
tor will operate using either vapor withdrawn liquid pro-
pane (LP gas) or natural gas (NG).
NOTE: This generator is suitable for supplying typical
residential and commercial loads such as induction
motors (sump pumps, refrigerators, air conditioners, fur-
naces, etc.), electronic components (computer, monitor,
TV, etc.), lighting loads, and microwaves, when sized cor-
rectly.
The information in this manual is accurate based on
products produced at the time of publication. The manu-
facturer reserves the right to make technical updates,
corrections, and product revisions at any time without
notice.

Read This Manual Thoroughly

WARNING
Consult Manual. Read and understand manual
completely before using product. Failure to
completely understand manual and product
could result in death or serious injury.
If any section of this manual is not understood, contact
the nearest Independent Authorized Service Dealer
(IASD) or Generac Customer Service at 1-888-436-3722
(1-888-GENERAC), or visit
ing, operating, and servicing procedures. The owner is
responsible for correct maintenance and safe use of the
unit.
This manual must be used in conjunction with all other
supporting product documentation supplied with the
product.
SAVE THESE INSTRUCTIONS for future reference. This
manual contains important instructions that must be fol-
lowed during placement, operation, and maintenance of
the unit and its components. Always supply this manual
to any individual that will use this unit, and instruct them
on how to correctly start, operate, and stop the unit in
case of emergency.
Installation Guidelines For Spark-Ignited Stationary Generators
(000100a)
www.generac.com
for start-
Safety Rules & General Information

Safety Rules

The manufacturer cannot anticipate every possible cir-
cumstance that might involve a hazard. The alerts in this
manual, and on tags and decals affixed to the unit, are
not all inclusive. If using a procedure, work method, or
operating technique that the manufacturer does not spe-
cifically recommend, verify that it is safe for others and
does not render the equipment unsafe.
Throughout this publication, and on tags and decals
affixed to the unit, DANGER, WARNING, CAUTION, and
NOTE blocks are used to alert personnel to special
instructions about a particular operation that may be haz-
ardous if performed incorrectly or carelessly. Observe
them carefully. Alert definitions are as follows:
DANGER
Indicates a hazardous situation which, if not avoided,
will result in death or serious injury.
WARNING
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
CAUTION
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
NOTE: Notes contain additional information important to
a procedure and will be found within the regular text of
this manual.
These safety alerts cannot eliminate the hazards that
they indicate. Common sense and strict compliance with
the special instructions while performing the action or
service are essential to preventing accidents.

How to Obtain Service

When the unit requires servicing or repairs, contact Gen-
erac Customer Service at 1-888-GENERAC (1-888-436-
3722) or visit
www.generac.com
When contacting Generac Customer Service about parts
and service, always supply the complete model and
serial number of the unit as given on its data decal
located on the unit. Record the model and serial numbers
in the spaces provided on the front cover of this manual.
(000001)
(000002)
(000003)
for assistance.
1

Advertisement

Table of Contents
loading

Table of Contents