Table of Contents
Advertisement
Unit Pages
85
To display the Management Addresses page, click IP Setup at the
bottom of the Unit Status page.
Management Address
This page specifies a unique IP address for the unit (which can be
used to access the stack over the network), as shown in
Figure
14.
If you have no previous knowledge of IP, refer to
"IP Addresses"
on
page 30. If you change any of these values, you may need to
re-access the stack using the new values.
Any changes that you make will take effect after a few seconds. You
do not need to reset the stack.
Figure 14 Management Address Page
The fields are:
IP Address Provides a box for you to type the IP address of the stack.
Subnet Mask Provides a box for you to type the subnet mask for the
IP address.
Default Router Provides a box for you to type the IP address of the
default router (if you have one) which is used by the stack to
communicate with other networks.
BOOTP Off / On
Specifies whether you want your BOOTP server (if you have one) to
automatically allocate the stack an IP address and subnet mask.
Advertisement
Table of Contents
