Parameters Backup And Restore With "Hot Key; Visualisation Of Compressors And Pumps Operating; Visualisation Of Compressors Starts Up; Visualisation Of Compressors Discharge Temperature - Emerson IC200CX EVO User Manual

8.4 Parameters backup and restore with "Hot Key"
8.5 Visualisation of compressors and pumps operating hours
Note: the hours of operation are shown in the upper display with a resolution of 10 hours (the
value 2 indicates that the hours of operation of that load are 20).
8.6 Visualisation of compressors starts­up
Note: the starts­up are shown in the upper display with a resolution of 10 (the value 2 indicates
that the starts­up are 20).
8.7 Visualisation of compressors discharge temperature
Using the UPL menu, the instrument parameters can
be stored in a "Hot Key" programming key. The key
must be inserted when the instrument is switched on.
Pressing the key the controller starts copying
the data; the UPL label is flashing. When the
procedure is completed, the END message is
displayed confirming that the copy has been correctly
executed, or Err in case of errors.
Through the Hour menu it is possible to view the
operating hours of the controlled loads:
• compressors operating hours (CO1H/CO2H)
• main pump operating hours (EP1H)
• sanitary water pump operating hours (SAPH)
Through the COSn menu it is possible to display the
number of compressors starts­up. The individual
compressors are identified by the C1S and C2S labels.
Through the COdt menu it is possible to display the
temperature value of the probes that control the
compressor discharge temperature.
• discharge temperature compressor n° 1 (CO1t)
• discharge temperature compressor n° 2 (CO2t)
IC200CX EVO
user manual
27