Wall/Ceiling Outlet Box Installation - Enterasys RoamAbout R2 Installation Manual

Wall/Ceiling Outlet Box Installation

Follow the step-by-step procedure below to install the RoamAbout R2 to an outlet box.
1. Make sure the site primary power for the RoamAbout R2 conforms to the
specifications detailed in
2. Select a wall or ceiling outlet:
— If using remote power, with internal 10BaseT/100BaseT Ethernet network cabling
installed.
— If not using remote power, within six feet of an AC electrical outlet:
a) If using redundant power (connecting both local power and remote power).
b) If using the local power option and not using the remote power option.
3. Remove the mounting bracket from the RoamAbout R2:
a) Completely loosen the captive screw.
b) Slide the bracket until the two screw slots are directly below the two screws.
c) Lift and remove the bracket from the RoamAbout R2.
4. Connect the Ethernet cable.
Chapter 2,
or
Mounting Bracket
Captive
Wall/Ceiling Outlet Box Installation
Cabling and Wiring.
Remove
Screw
Screw
Slot
Screw
3-3