Verifying The Operation Of The Roamabout R2 - Enterasys RoamAbout R2 Installation Manual

Verifying the Operation of the RoamAbout R2

Verifying the Operation of the RoamAbout R2
The RoamAbout R2 runs a series of self-tests on power-up and reports status using its
LEDs. The diagnostics take several seconds to complete after power-up. Table 3-1
describes the LEDs. If the RoamAbout R2 LEDs indicate an error, verify that you have
correctly installed the RoamAbout R2. Table 3-2 describes the patterns, the most likely
causes, and possible corrective actions. If the RoamAbout R2 still fails, refer to the
RoamAbout 802.11 Wireless Networking Guide.
The Reload/Reset button is used to download a new firmware image to the RoamAbout R2,
and to reset the RoamAbout R2 to the factory defaults. You need to write down the MAC
address (in the MAC ADD box) for use when configuring the RoamAbout R2.
Once the RoamAbout R2 is installed and powered on, refer to the RoamAbout 802.11
Wireless Networking Guide to set the RoamAbout R2 parameters.
3-19