Speed Controller Of No.13410; Speed Controller Technical Data; Commissioning The Speed Controller; Programming The Controller To Your Throttle Stick - GRAUPNER Husky 1800S Manual

Speed controller of No.13410

Speed controller technical data

Commissioning the speed controller

Programming the controller to your throttle stick

13410_13410.100_HU_V.1
Weight incl. leads
EMK brake
Continuous current at 25°C
Peak power consumption 10 sec.
Cell count LiPo, Lilo:
Operating voltage
Dimensions approx.
BEC receiver current supply:
Servo operating voltage
Servos max.
Speed controller
Maximum motor RPM 2 poles
Maximum motor RPM 6 poles
Maximum motor RPM 12 poles
Automatic under-voltage cut-off
Automatic thermal protection
Automatic motor reduction if signal is lost
NOTE
The speed controller can be operated with different transmitters
from different manufacturers, in order to ensure optimal opera-
tion, it is therefore necessary to adjust the controller to your trans-
mitter.
1. Move the throttle stick to the full throttle position and connect
the drive battery, the motor plays the melody "Do Re Mi".
2. After 2 seconds the motor beeps with 2 long sounds (B-- B--)
then the controller has detected the full throttle position. Move
the throttle stick to the stop position within the next 2 seconds
after the sounds (B-- B--), then the controller has detected the
stop position.
3. After a long (B--) the setting is completed and the controller is
ready to start.
48 g
Programmable
40 A
55 A
2 - 4
7,4 - 16,8 V
65 x 25 x 12 mm
5 V / 4 A
4,8 - 6 V DC
5
40 A
210000 RPM
70000 RPM
35000 RPM
YES
110 °C
YES
23 / 76