Danfoss IKORE Installation Manual

Hide thumbs Also See for IKORE:

Download this manual

Installation Guide

Remote Control

IKORE + R11

Danfoss does not take responsibility for incorrect installation or

any frequency interference.

Chance of unintended machine movement on start up.

Ensure the machine is stopped for the entire duration of the

assembly process.

Keep the work area free and wear protective clothing.

To guarantee the specified autonomy or the product, it is

necessary to use AAA LR03 (x3) Alkaline batteries with nominal

capacities between 900 and 1155 mAh. It is highly

recommended to use brands with PLUS type or similar with

nominal capacities close to 1155 mAh. Rechargeable batteries

are not recommended because of their lower nominal capacity.

1. Connect the power supply and the outputs according to

the connection block diagram provided with the system.

The configuration of the radio node can last up to 1 minute.

2. Insert the EEPROM and the batteries.

3. Push and pull out the STOP button.

The status LED will pulse blue until the stand by mode is

reach, then it will turn into a continuous blue.

[2]

[3]

[1]

4. Press the start button.

Danfoss | December 2018

The status LED will pulse green until the transmitter is

linked with the receiver. The LED will turn into a continuous

green when the receiver confirms the link.

The system is now fully operational.

AN290872682441en-000101 | 1

Page 1 Remote Control IKORE + R11 The status LED will pulse green until the transmitter is Danfoss does not take responsibility for incorrect installation or linked with the receiver. The LED will turn into a continuous any frequency interference. green when the receiver confirms the link.
Page 2 * Data sheet Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products already on order provided that such alterations can be made without subsequent changes being necessary in specifications already agreed.

R11