Table of Contents
Advertisement
2. Remove the two screws (M2 x 2.7), and then remove the USB bracket.
3. Remove the four screws (PSW2 x 5), and then remove the UI-32 board.
Note
•
When attaching the UI-32 board, tighten the screws in the following sequence: (a), (b), (c), (d).
•
When attaching the USB bracket, tighten the screws in the following sequence: (e), (f).
4. Install the removed parts by reversing the steps of removal.
PSW2 x 5
(a)
(b)
(c)
USB bracket
(d)
UI-32 board
(f)
(e)
Special head screws (M2 x 2.7)
95
Advertisement
Table of Contents
