Table of Contents
Advertisement
Procedure
1. Remove the two tapes AS 1/2, and then disconnect the fine-wire coaxial cable from the connector
(CN700) on the BD-48 board.
Tip
When connecting or disconnecting the fine-wire coaxial cable, refer to "1-12-2.
Disconnecting/Connecting Fine-Wire Coaxial Cable".
Arrangement of fine-wire coaxial cable
Note
At the time of the installation, arrange the fine-wire coaxial cable as shown in the figure.
Tapes AS 1/2
Fine-wire coaxial cable
Fine-wire coaxial cable
Tapes AS 1/2
BD-48 board
CN700
89
Advertisement
Table of Contents
