2-2-4. Cleaning after Operation in Special Environment
After the unit has been used in a seaside, sandy place, humid place, or dusty place, perform the following
procedure.
Note
Do not touch the part (slide shaft) to which oil is applied in the drive during cleaning.
If oil adheres to the cleaning cloth, replace it with new one.
If a cleaning cloth with oil is used, the oil may adhere to unnecessary parts.
Tools
•
Vacuum cleaner
•
Cleaning cloth (or cotton swab)
•
Cleaning fluid (alcohol)
•
Cartridge (PFD23A, PFD50DLA, etc.)
Procedure
1. Clean the connectors on the rear of the unit.
2. Remove sand and dust from the following parts with a vacuum cleaner.
•
Power button
•
EJECT button
•
Manual eject mechanism
•
Disc slot
•
Intake air vent
•
Exhaust air vent
Disc slot
Intake air vent
EJECT button
3. Remove the cabinet parts. (Refer to "4-2. Removing/Installing the Cabinet".)
4. Carefully remove dust and sand from the unit.
5. Remove the front frame assembly. (Refer to "4-10. Front Frame Assembly".)
Manual eject mechanism
Power button
Exhaust air vent
Connectors
26