Switch 4005 Chassis; Overview - 3Com 4005 Installation And Maintenance Manual

4

Overview

S 4005 C
WITCH
This chapter describes how to install the 3Com Switch 4005 chassis. The main
sections in this chapter are as follows:
Overview
I
Preinstallation Guidelines
I
Installing the Chassis
I
Installing the Cable Management Device
I
The basic steps that comprise a chassis installation are as follows:
1 Confirm that the installation area (rack, table, or shelf) is ready to receive the
chassis, in terms of the site requirements and safety information provided in
Chapter 3.
2 Read the pre installation guidelines, cautions, and warnings in this chapter before
you begin the installation procedure.
3 (Rack installation only) Attach the flanges to the chassis. These are included in the
chassis shipping box.
4 Use at least two people to install the chassis and follow the appropriate
procedures in this chapter.
5 (Optional, rack installation only) Attach the cable management device, which is
included in the chassis shipping box, to the rack.
WARNING: The Switch 4005 chassis and its components must be installed,
maintained, or replaced only by trained service personnel. This guide assumes that
the network administrator has a working knowledge of local area network (LAN)
operations. Furthermore, this guide assumes that the network administrator has
obtained appropriate technical training and experience to perform tasks in service
access areas of network equipment, to be aware of electrical hazards that exist in
performing these tasks, and to take steps that minimize the danger to themselves
or other persons. If you have questions on installation tasks, contact your network
supplier or 3Com technical support. See Appendix A for contact information.
WARNING: You can install the Switch 4005 chassis on a table or a shelf or into a
rack. To minimize the risk of personal injury or equipment damage, 3Com
recommends that at least two people perform a chassis installation.
HASSIS