Table of Contents
Advertisement
1. Overview
2. Installation & wiring
General terms, abbreviations, and terminology used in this manual
The general terms, abbreviations, and terminology used in this manual are as follows.
Item
WB1F
RS-232 type
USB type
Communication interface
Prevention time of same
read
Number of characters
AIM ID
AI
Pitch
Skew
Tilt
Light receiving axis
Reading timeout
Receive buffer
Send buffer
Quiet zone
Control characters
Prefix
Suffix
Output
Input
IDEC website
3. Functions
An abbreviation for the WB1F-100S1B and the WB1F-100S1S.
The type that uses RS-232 for the communication interface. (The cable end must be fabri-
cated.)
(WB1F-100S1B)
The type that uses USB for the communication interface.
(WB1F-100S1S)
Refers to the RS-232 interface and the USB interface.
The wait time to prevent reading the same barcode twice when reading barcodes consecu-
tively.
Refers to the total number of 1-byte codes that are sent and received from the RS-232 inter-
face and the USB interface.
An abbreviation for AIM-compliant symbology identification ID.
An abbreviation for Application Identifier which GS1 standardized.
Refers to the rotation angle of the barcode symbols for the axis parallel to the bar height.
For details, refer to
F P. 5-3 "5. 2. 2 Angular
Refers to the rotation angle of the barcode symbols for the axis parallel to the barcode sym-
bol length. For details, refer to
Refers to the rotation angle of the barcode symbols for the axis perpendicular to the bar-
code symbol. For details, refer to
The axis that provides the image of the reflected light from the barcode to the WB1F inter-
nal CCD.
The time after a reading request turns on until reading is automatically turned off. This time
is applied when a factor does not occur that is supposed to turn reading off such as reading
succeeded, external trigger input off, and the stop reading command.
A storage area that temporarily stores received data.
A storage area that temporarily stores send data.
The margins to the left and right of the barcode.
ASCII codes 00H to 1FH and 7FH. In this manual, they are expressed using
refer to
F P. 5-11 "5. 7 ASCII code
Character data that is added to the beginning of output data and communication com-
mands.
Character data that is added to the end of output data and communication commands.
Output is the general term for communication output, OK output, NG output, PWM output,
and the indicator LED.
Input is the general term for the Operation button, external trigger input, and communica-
tion input.
www.idec.com
4. Support tool
General terms, abbreviations, and terminology used in this manual
Details
characteristics".
F P. 5-3 "5. 2. 2 Angular
characteristics".
F P. 5-3 "5. 2. 2 Angular
table".
5. Appendix
characteristics".
. For details,
iii
Advertisement
Table of Contents
