Maintenance Mode; Switching Operation To Maintenance Mode - IDEC WB1F Series User Manual

1. Overview 2. Installation & wiring
3. 4

Maintenance mode

This mode is used for maintenance during operation after WB1F installation and to perform actions when problems occur.
Maintenance mode has the following functions.
Maintenance support ............................................
z
Firmware updating .................................................
z
3. 4. 1

Switching operation to maintenance mode

There are two methods to switch to maintenance mode.
Use the methods depending on maintenance and the situation when a problem occurs.
The indicator LEDs (red/orange/green) will all flash (2 seconds on, 2 seconds off ) when switching to maintenance mode.
Method 1
You can switch to maintenance mode with the Operation button.
For details, refer to
Method 2 Input the "switch to maintenance mode" control command.
For details, refer to
Function
F P. 3-35
F P. 3-35
F P. 3-34 "Detailed procedure using the Operation
F P. 5-6 "5. 5 Control commands
4. Support tool
button".
list".
5. Appendix
Maintenance mode
RS-232 Type USB Type
3-33