Kenwood XD-DV9 Instruction Manual page 56

56
Remote control unit
Symptom
Remote control operation is not possible.
Cassette deck
Symptom
Sound cannot be produced by pressing
the play key or no operation occurs even
when an operation key is pressed.
No operation occurs even when an opera-
tion key is pressed.
Sound is harsh or high frequencies are not
reproduced.
Noise is noticeable.
Sound vibrates.
Recording cannot be started by pressing
the record key.
1. With some tapes, a squeaky noise is produced when the tape is stopped automatically. This is due to the tape protection function,
and not a malfunction.
Notes Notes
2. Do not use longer tape than 110 minutes tapes, for the tape is too thin and gets easily tangled.
Cause
÷ Batteries are exhausted.
÷ The remote control is too far away from the
system, the controlling angle is deviated or
there is an obstacle in between.
÷ There is no tape or CD set in the component
to be played.
Cause
÷ The head is dirty.
÷ The tape is wound too tight due to irregular
winding.
÷ A nonrecorded tape is played.
÷ The cassette holder is not closed com-
pletely.
÷ A tape is not inserted in the unit.
÷ The tape is wound too tight due to irregular
winding.
÷ The tape is fully wound to one of the reels.
÷ The head is dirty.
÷ The tape is stretched or shrunk.
÷ The tape head is magnetized.
÷ External noise is induced.
÷ A tape recorded with Dolby NR ON is being
played on this unit.
÷ The capstans or pinch rollers are dirty.
÷ The tape is wound irregularly.
÷ The recording protect tab of the cassette
has been broken.
÷ The cassette holder is not closed com-
pletely.
÷ The tape is fully wound to one of the reels.
In case of difficulty
Remedy
÷ Replace with new batteries.
÷ Operate the unit inside the remote control-
lable range.
÷ Set a tape or CD in the component to be
played.
Remedy
÷ Clean the head referring to "Maintenance".
÷ Try another tape.
÷ Play a recorded tape.
÷ Close the holder completely.
÷ Insert a tape.
÷ Try another tape.
÷ Reverse the tape insertion orientation.
÷ Clean the head referring to "Maintenance".
÷ Try another tape.
÷ Demagnetize the head referring to "Main-
tenance".
÷ Install the system at a distance from other
electric appliances and TV.
÷ This unit can not play tapes recorded with
Dolby NR ON with the correct sound quality
÷ Clean the head referring to "Maintenance".
÷ Wind the tape again by fast forwarding,
rewinding or playing from an end to the
other.
÷ Use a cassette with an unbroken recording
protect tab or block the hole.
÷ Close the holder completely.
÷ Reverse the tape insertion orientation.
%
%
°
(
R
°
°
R
R
R
°
9
·
·