TM
FST1, 2, 3
Temp Sensors
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
• Follow safe electrical work practices. See NFPA 70E in the USA, or applicable local codes.
• This equipment must only be installed and serviced by qualified electrical personnel.
• Read, understand and follow the instructions before installing this product.
• Turn off all power supplying equipment before working on or inside the equipment.
• Use a properly rated voltage sensing device to confirm power is off.
DO NOT DEPEND ON THIS PRODUCT FOR VOLTAGE INDICATION
Failure to follow these instructions will result in death or serious injury.
A quali ed person is one who has skills and knowledge related to the construction and
operation of this electrical equipment and the installation, and has received safety
training to recognize and avoid the hazards involved.
No responsibility is assumed by Veris Industries for any consequences arising out of the
use of this material.
NOTICE
• This product is not intended for life or safety applications.
• Do not install this product in hazardous or classified locations
other than those listed in Specifications.
• Read and understand the instructions before installing
this product.
• Turn off all power supplying equipment before working on it.
• The installer is responsible for conformance to all applicable codes.
No responsibility is assumed by Veris Industries for any consequences arising out of the
use of this material.
Z205739-0D
PAGE 1
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Aerospond, Veris, and the Veris 'V' logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
FLOW SENSORS
FSR
FST4, 5
NEC2009 Article 100
©2013 Veris Industries
INSTALLATION GUIDE
FSRxxxx SERIES
Ultrasonic Flow Meter
PRODUCT IDENTIFICATION
Monitor: FSR Series
Transducers: FST1, FST2, FST3, FST4, FST5
Note: Do not cut transducer cables to alter length. This will void the
factory warranty. Cables are available in several lengths. Assess the
installation location prior to ordering to determine the optimum length.
If the wrong length is ordered, contact the factory.
DIMENSIONS
FSR Monitor
6.4"
(163 mm)
6.0"
(153 mm)
1.4"
(35 mm)
4.1"
(105 mm)
4.3"
(110 mm)
2.1"
(53 mm)
0.75"
(19 mm)
2x 0.5"
(13 mm)
05131