Veris Industries H81 Series Installation Manual

H81xx
AH06 (optional
mounting bracket)
Z205338-0C PAGE 1
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Veris, and the Veris 'V' logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
POWER MONITORING
©2009 Veris Industries USA 800.354.8556 or +1(0)503.598.4564 / support@veris.com
INSTALLATION GUIDE
H81xx
Energy Meter
Installer's Specifications
Insulation Class
Sample Rate
Internal Isolation
Operating Temp. Range
Storage Temp. Range
Accuracy ±1% of reading from 2% to 100% of the CT current rating **
Power Consumption
Voltage Tolerance:
H8150 Control Power
H8163 Control Power
Electrical Services:
H8150 120/240 VAC with neutral, 208Y/120 VAC line-to-neutral
H8163 Any service in which the phase A-N voltage is ≤300VAC and
the phase-to-phase voltage is ≤480 VAC nom. with neutral
Frequency
Pulse Output (H8163 only)
Pulse Rate (H8163 only) 0.10, 0.25, 0.50, 1.00 kWh per pulse (jumper selectable)
Pulse Width (H8163 only)
Phase Loss Alarm Output (H8163 only)
Safety UL 3111-1 Cat. III pollution degree 2, alt. 0-2000 meters
Protection Class
* Do not apply 600V class current transformers to circuits having a phase-to-phase voltage
greater than 600V without adequate additional insulation between primary conductor and
current transformers.
** Meters and current transformers are calibrated as a set. To achieve this accuracy, match the
serial numbers on the transformers and the meter at the time of installation.
quick install
1. Verify that serial numbers on meter and current transformers match.
2. Mount the meter housing.
3. Attach current transformer(s) to the conductor.
4. Connect voltage leads.
5. Use color coding to connect current transformer leads to the input terminals and
voltage leads to phase conductors (e.g. red to red).
6. Connect the Pulse and Phase Loss output terminals to the controller (H8163 only).
7. Set the backlight and display data jumpers as desired.
8. Set the Pulse Rate selection switch as desired (H8163 only).
9. Secure the cover.
10. Apply power to the meter.
0° to 50°C (32° to 122°F) (<95%RH, non-condensing)
-40°C to 70°C (-40° to 158°F)
90 to 132VAC line-to-neutral
90 to 300VAC line-to-neutral
N.O., Opto-Fet, 100mA@240VAC/DC
200msec closed
N.O. (opens on alarm), Opto-Fet, 100mA@24VAC/DC;
Fixed threshold 25% below any other phase;
remains open while alarm persists
600VAC *
1280 Hz
2500VAC
50 VA
50/60 Hz
NEMA 1
07091