Table of Contents
Advertisement
QNP3 Hardware Manual
Chapter 3: Electrical Specifications and Installation
W A R N I N G : Electrical installation must be performed by properly qualified personnel.
Aerotech motion control systems are adjusted at the factory for optimum performance. When the QNP3 is
part of a complete Aerotech motion control system, setup usually involves connecting a stage to the
appropriate drive chassis with the cables provided. Labels on the system components usually indicate the
appropriate connections.
If system level integration was purchased along with the stage, an electrical drawing showing system
interconnects has been supplied with the system (separate from this documentation).
The electrical wiring from the piezo stage and optional feedback device are integrated at the factory. Refer to
the following sections for standard wiring and connector pinouts.
W A R N I N G : Operator access to the base and tabletop must be restricted while connected to
a power source. Failure to do so may cause electric shock.
D A N G E R : Remove power before connecting or disconnecting electrical components or
cables. Failure to do so may cause electric shock or damage to the equipment.
W A R N I N G : Applications requiring access to the stage while it is energized will require
additional grounding and safeguards. The System Integrator or qualified installer is responsible
for determining and meeting all safety and compliance requirements necessary for the
integration of this stage into the final application.
www.aerotech.com
Electrical Specifications and Installation
Chapter 3
27
Advertisement
Table of Contents
