Piezo Connectors - Aerotech QNP3 Series Hardware Manual

Electrical Specifications and Installation

3.1. Piezo Connectors

N O T E : Refer to the other documentation accompanying your Aerotech equipment. Call your Aerotech
representative if there are any questions on system configuration.
The protective ground connection of the QNP3 grounds the entire stage frame to the common grounds on the
stage connectors. The coating on the stage is not electrically conductive. Additional grounding and safety
measures are required for applications requiring access to the stage while it is energized. The System
Integrator or qualified installer is responsible for determining and meeting all safety and compliance
requirements necessary for the integration of this stage into the final application.
D A N G E R : Remove power before connecting or disconnecting electrical components or
cables. Failure to do so may cause electric shock or damage to the equipment.
W A R N I N G : Operator access to the base and tabletop must be restricted while connected to
a power source. Failure to do so may cause electric shock.
C A U T I O N : The stage controller must provide voltage range and over-speed protection.
Failure to do so may result in permanent damage to the actuator and stage components.
28 Chapter 3
QNP3 Hardware Manual
www.aerotech.com