Bell System Practices Plant Series Adjustments page 52

573-115-700
SECTION
2. 48
Positioning Mechanism (Cont.)
(TOP V
NOTE: FOR SHIFT MECHANISMS WITH TORSION SPRINGS SEE
52
Page
( )
A SHIFT LINKAGE
REQUIREMENT
CARRIAGE NEAR MIDPOINT OF PLATEN. TYPE BOX IN POSITION TO PRINf
0
LETTER MANUALLY BUCKLE RIGHT SHIFT LINKAGE.
" ".
TO LEFT. FIGURE
P T NG HAMMER
R I N I
EW)
I
(FRONT VIEW)
"9" TYPE PALLET SHOULD BE APPROXIMATELY IN CENTER
OSCILLATOR RAIL WITH TWO CLAMP
SCREWS LOOSENED.
TO RECHECK
SHIFT ALTERNATELY FROM "W" TO
2
" ".
ECTION. REFINE ADJUSTMENT IF
NECESSARY.
RIGHT SHIFT Ll1'lKAGE
CJD
SHIFT LINKAGE SPRING
REQUIREMENT
PAR. 4.15
SHIFT TYPE BOX
LEFT SHIFT LINKAGE ON
TAKE UP PLAY IN EACH DIR-
LINK IN STRAIGHT POSITION
MIN. 6 OZS.
14
MAX. OZS.
TO START EACH LINK MOVING.
•