Bell System Practices Plant Series Adjustments page 51

Printing Mechanism (Cont.)
2.47
NOTE:
,.
CLAMP SCREW S
STOP BRACKET
CHECK RELATED ADJUSTMENTS, PARS .
ADJUSTMENT S ARE REMADE. FOR TYPING UNITS OF EARLIER DESIGN, CHECK RELATED
(TOP VIEW)
PERIOD TYPE PALLET
(RIGHT SIDE VIEW)
2.30, 2.38,
PRINTING HAMMER
PRINTING CARRIAGE POSITION
TYPE BOX IN L-HTERS POSITION.
SELECTED.
OF PLATEN.
M TYPE PALLET SHOULD BE APPROXIMATELY IN
CENTER OF PRINTING HAMMER v'v'HEN HAMMER
IS JUST TOUCHING M TYPE PALLET.
PLAY IN TYPE BOX CARRIAGE IN EACH DIRECTION
AND SET HAMMER IN CENTER OF PLAY.
TO ADJUST
POSITION PRINTING CARRIAGE ON WIRE ROPE
WITH CLAMP SCREWS LOOSENED.
REQUIREMENT
TO ADJUST
ISS 7, SECTION
AND IF THE FOLLOWING
2.44,
CARRIAGE AT APPROXIMATE MIDPOINT
TYPE BOX IN PRINTING POSITION.
573-115-700
M TYPE PALLET
TAKE UP
Page 51