Engine Coolant - Can-Am DS 250 Instructions Manual

vbl2006-008-022
GEARBOX OIL LEVEL VERIFICATION
9. Ensure there is a MINIMUM of 25 mm (1 in) of
oil on the wire.
10. Reinstall and screw in filler plug completely.

Engine Coolant

WARNING
Check coolant level with engine cold. Never
add coolant in cooling system when engine is
hot.
Recommended Engine Coolant
Use
BRP PREMIXED COOLANT (P/N 219 700 362)
a mix of ethylene-glycol/water (50% coolant, 50%
distilled water).
Coolant Level Verification
NOTICE
Do not overfill coolant reservoir.
When checking level at temperatures be-
NOTE:
low 20°C (68°F), level may be slightly below MIN
mark.
Canada and USA models
1. Park vehicle straight on a level surface.
2. Lift out front fascia from both sides rubber
grommets.
3. Carefully pull front fascia toward front.
4. Remove front fascia from vehicle.
PREDELIVERY
vbl2006-008-018_a
1. Rubber grommets
5. Check that radiator is filled with coolant by re-
moving the radiator cap.
6. If necessary, add recommended coolant.
7. Reinstall radiator cap.
or
vmo2006-014-031_a
1. Radiator cap
2. Coolant reservoir cap
8. Locate coolant reservoir underneath RH front
fender.
9. Check coolant reservoir level.
10. Ensure that fluid is between MIN. and MAX.
marks.
2011-2
FLUIDS
9 / 16