Gearbox Oil - Can-Am DS 250 Instructions Manual

FLUIDS
vbl2006-008-014_a
1. Engine oil dipstick
4. Wipe dipstick.
5. Reinstall dipstick (do not screw it in).
6. Remove dipstick.
7. Check oil level as per the following illustration.
vbl2006-008-015_b
UPPER MARK (FULL)
8. Ensure that oil level is close to or on upper mark
(Full).
9. If necessary, add recommended engine oil .
10. Reinstall and screw in dipstick completely.

Gearbox Oil

Recommended Gearbox Oil
Use
XPS CHAINCASE OIL (P/N 415 129 500)
8 / 16
NOTICE
of oil when servicing. Do not mix with other
types of oil.
Gearbox Oil Level Verification
NOTICE
free of greasy matter) wire to avoid oil contam-
ination.
The following procedure is not an accurate
NOTE:
one, it must be only used to verify the presence
of oil in the gearbox. If necessary, refer to the ap-
propriate ATV SHOP MANUAL
cedure.
1. Park vehicle straight on a level surface.
2. Select NEUTRAL position.
3. Apply parking brakes.
4. Remove the gearbox filler plug.
5. Get a piece of 16-18 gauge clean wire,
305 mm to 380 mm (12 in to 15 in) long.
6. Insert approximately 203 mm (8 in) in a down-
ward angle into the filler hole.
vbl2006-008-021_a
INSERT WIRE INTO FILLER HOLE
7. Pull wire out the filler hole.
8. Check gearbox oil level as per the following il-
lustration.
.
2011-2
Do not use non recommended types
Make sure to use a clean (completely
for complete pro-
PREDELIVERY