3. Keep rear axle on 2 rear U-brackets.
vbl2006-008-023_a
1. Rear U-brackets
4. Lift front of vehicle.
5. Install front wheels on vehicle with air valves
toward the outside.
6. Ensure that the rotation direction shown by the
arrow is respected.
NOTICE
Respect the rotation direction shown
by the arrow on the outside wall of the tire.
vbl2006-008-005_a
7. Torque wheel lug nuts to 50 N•m (37 lbf•ft).
8. Lift vehicle from rear U-brackets.
9. Install rear wheels on vehicle with air valves to-
ward the outside.
10. Ensure that the rotation direction shown by
the arrow is respected.
11. Torque wheel lug nuts to 50 N•m (37 lbf•ft).
12. Move vehicle out of the crate.
PREDELIVERY
Mirrors
On applicable models, install both right side and
left side mirrors.
Vehicle Decals
1. Install decals on vehicle according to customer
country language and local legislation.
2. Ensure that the new decals are installed at the
same location and over the factory installed de-
cals.
Accessories Installation
1. Install accessories (if any) as per their installa-
tion instructions (included in each kit).
2. Install any other equipment required by local
legislation (if any).
Handlebar
Some air bubbles may be present in the
NOTE:
brake lines due to the handlebar's disposition
within the crate. Installing the handlebar as early
as possible will allow the air bubbles to move
from the brake lines to the master cylinder. The
brake system does not need to be bled. The
brake system pressurization will be completed
further in this section.
Canada and USA models
1. Remove and discard the 4 handlebar retaining
bolts.
vbl2006-008-006_a
HANDLEBAR RETAINING BOLTS
2. Park vehicle straight on a level surface.
3. Position handlebar so both brake fluid reser-
voirs are level.
4. Align steering pod bracket.
2011-2
PARTS TO BE INSTALLED
5 / 16