Parts To Be Installed; Battery; Wheels - Can-Am DS 250 Instructions Manual

PARTS TO BE INSTALLED

11. Remove protective wrapping all over vehicle.
vbl2006-008-004
CUT RETAINING STRAPS
PARTS TO BE INSTALLED

Battery

1. Refer to the latest edition of
TERY SERVICE BULLETIN
vating, charging and maintenance procedures.
NOTICE Always charge battery before its in-
stallation on the vehicle.
2. Remove seat by pulling underneath latch at
rear.
vbl2006-008-011_a
SEAT LATCH
3. Install charged battery on vehicle, positive post
on right side.
Never charge or boost battery
CAUTION
while installed on vehicle.
4. Secure battery in place using supplied bracket
with its 2 retaining bolts and washers.
4 / 16
CAN-AM ATV BAT-
for the proper acti-
2011-2
NOTICE Make sure not to squeeze battery ca-
bles between vehicle components.
5. Apply
DIELECTRIC GREASE (P/N 293 550 004)
battery posts.
6. Connect RED positive cable to positive battery
post using supplied nut and bolt.
7. Connect BLACK negative cable to negative bat-
tery post using supplied nut and bolt.
NOTICE Always connect RED positive cable
first and then BLACK negative cable.
8. Cover positive post with rubber boot.
vbl2006-008-012
BATTERY INSTALLATION
9. Reinstall seat.

Wheels

1. Cut straps retaining wheels to end steel
frames.
2. Inflate tires to specified air pressure.
WARNING
Low pressure may cause tire to deflate and
rotate on wheel. Overpressure may burst the
tire. Always follow recommended pressure.
Since these tires are low pressure type, a
manual pump should be used.
NOTICE Always check pressure when tires are
cold.
TIRE PRESSURE
Recommended
Minimum
on
FRONT REAR
34 kPa 34 kPa
(5 PSI) (5 PSI)
26 kPa 26 kPa
(4 PSI) (4 PSI)
PREDELIVERY