Temp - Canon WUX500ST User Commands

TEMP

Temperature sensor value inquiry
Format
Setting Command
Response
Reference Command
Response
Environment
Power mode restriction
LAN
SL0 SL1 SL3 PM ON SL0 SL1 SL3 PM ON ST PM ON D-RGB A-RGB COMP HDMI HDBT LAN USB
No No Yes Yes Yes No No No No Yes Yes Yes Yes
Remarks
(1) There are cases when number of sensors is 0. In this case, there will not be a comma.
Example
> GET=TEMP
< g:TEMP=5,28.5,53.3,53.3,53.3,33.0
Note: '>' indicates a command; '<' indicates a response.
-
-
GET=TEMP
g:TEMP=<Number of sensors>,<Sensor 1 value>,...,<Sensor n
value>
Note: See "Error list" for any response other than the above.
WiFi RS-232C
Yes
References the temperature sensor value.
-87-
WUX500ST User Commands
Input
Yes Yes Yes Yes Yes Yes
No
signal Yes