Maintenance; Warning Temp. Indicator; Air Filter Care And Cleaning; Cleaning Projection Lens - Canon LV-7545 Owner's Manual

APPENDIX
WARNING TEMP. Indicator flashes red when an internal temperature of a projector exceeds the normal temperature. This
Indicator stops flashing when the temperature of a projector returns to normal.
When WARNING TEMP. Indicator continues to flash, check the items listed below.
Ventilation Slots of the projector may be blocked. In such an event, reposition the projector so that Ventilation Slots
1
are not obstructed.
2 Air Filter may be clogged with dust particles. Clean Air Filter by following the section AIR FILTER CARE AND
CLEANING below.
If WARNING TEMP. Indicator remains on after performing the above checks, Cooling Fans or the Internal Circuits may
3
be malfunctioning. Contact service personnel from an authorized dealer or a service station.
Removable Air Filter prevents dust from accumulating on the surface of Projection Lens and Projection Mirror. Should Air
Filter become clogged with dust particles, it will reduce Cooling Fans' effectiveness and may result in internal heat build up
and adversely affect the life of the projector. Clean Air Filter following the steps below:
Turn off the projector, and disconnect AC power cord from the
1
AC outlet.
Turn the projector upside down and remove Air Filter (2 used) by
2
pulling the latches upward.
Clean Air Filter with a brush or wash out dust and particles.
3
4 Replace Air Filter properly. Make sure that Air Filter is fully
inserted.
CAUTION
Do not operate the projector with Air Filter removed. Dust
may accumulate on LCD Panel and Projection Mirror
degrading picture quality.
Do not put small parts into Air Intake Vents. It may result in
malfunction of the projector.
RECOMMENDATION
We recommend avoiding dusty/smoky environments when operating a projector. Usage in these environments
may cause poor image quality.
When using under dusty or smoky conditions, dust may accumulate on a lens, liquid crystal panels, or optical elements
inside the projector. This condition may degrade the quality of a projected image.
When the above symptoms are noticed, contact your authorized dealer or service station for proper cleaning.
Follow these steps to clean Projection Lens:
Apply a non-abrasive camera lens cleaner to a soft, dry cleaning cloth. Avoid using an excessive amount of cleaner.
1
Abrasive cleaners, solvents or other harsh chemicals might scratch a surface.
Lightly wipe a cleaning cloth over Projection Lens.
2
3 When the projector is not in use, replace Lens Cover.
38

MAINTENANCE

WARNING TEMP. INDICATOR

AIR FILTER CARE AND CLEANING

CLEANING PROJECTION LENS

AIR FILTER
Pull up and remove.