Input Mode Read Command; Lamp Time Read Command; Setting Read Command; Temp Read Command - Canon LV-7575 Specifications

LV-7575 Basic Serial Command Functional Specifications

7.4 Input Mode Read Command

Command "CR1" [CR]
Detail Get currently selected Input No.
Acceptable
Response
Unacceptable

7.5 Lamp Time Read Command

Command "CR3" [CR]
Get total lamp running hours.
Detail *return lamp operating time multiplied by the given coefficient (not actual used
time)
Acceptable
Response
Unacceptable

7.6 Setting Read Command

Command "CR4" [CR]
Detail Get screen setting status such as Ceiling/Rear.
Acceptable
Response
Unacceptable

7.7 Temp Read Command

Command "CR6" [CR]
Get the information of temperature inside a projector.
Detail
With several built-in temperature sensors, it can get all the temperatures at once.
Acceptable
Response
Unacceptable
"%1" [CR]
"1" = Input 1 is selected.
"2" = Input 2 is selected.
%1
"3" = Input 3 is selected.
"4" = Input 4 is selected.(only for Networking-capable models)
"?" [CR]
"%1" [CR]
Display Lamp running hours with 5 digit numbers.
%1 Example:
"00410" [CR] ---------- 410 hours
"?" [CR]
"%1" [CR]
"11" [CR] = Normal Screen Setting
"10" [CR] = Picture is top/bottom reversed. (Status: Rear & Ceiling
ON)
%1
"01" [CR] = Picture is left/right reversed. (Status: Rear ON)
"00" [CR] = Picture is top/bottom and left/right reversed. (Status:
Ceiling ON
"?" [CR]
"%1 _ %2 _ %3" [CR]
%1 = Temp. of sensor 1
%2 = Temp. of sensor 2
%3 = Temp. of sensor 3
Temperature data basic format is "_00.0". ("_" indicates a space)
When the temperature goes under 0, it starts with "-" instead of a
%1 space like "-05.5" [CR].
%2 When no temperature data returns due to hardware problems, it
%3 starts with "E" like"E00.0" [CR].
With several built-in temperature sensors, the projector returns
the values in succession.
"_31.5_ _35.2_ 33.4 " [CR]
The first sensor's data is followed by one space and afterwards
the second sensor's data.
"?" [CR]
25/26
)