General Safety Practices - Mitel Mediatrix Model M Hardware Installation Manual

General Safety Practices

Warning: Do not use this product near water, for example, near a bath tub, wash bowl, kitchen
sink or laundry tub, in a wet basement or near a swimming pool.
Warning: Do not expose the unit to rain or moisture to avoid any shock hazard.
Warning: Do not use the telephone to report a gas leak in the vicinity of the leak.
Warning: Do not get this product wet or pour liquids into it.
Warning: Ultimate disposal of this product should be handled according to all national laws and
regulations.
Caution: If the unit is installed in a closed environment or on a multi-unit rack, the ambient
temperature of the environment next to the Mitel unit may become greater than the maximum
operating temperature recommended by Mitel for the use of its units, i.e. 40ºC. The Mitel GX
Gateway should never be used to temperatures greater than the recommended maximum
operating temperature. Any damage occurring in such environmental conditions will void the
warranty.
• Keep your Mitel GX Gateway clear and dust-free during and after installation.
• Locate the emergency power-off switch for the room in which you are working. Then, if an
electrical accident occurs, you can act quickly to turn off the power.
• Do not work alone if potentially hazardous conditions exist.
• Never assume that power is disconnected from a circuit. Always check.
• Do not perform any action that creates a potential hazard to people or makes the equipment
unsafe.
• Do not open or disassemble this product.
• The unit should be located at 20 cm from your monitor, computer casing or other peripheral
including speakers.
• When the unit is brought from a cold to a warm environment, condensation, that might be
harmful to the unit, may occur. If this is the case, wait one hour before powering the unit.
GX Gateway Hardware Installation Guide
7