Table of Contents
Advertisement
Installing the Mitel GX Gateway
Before you start
Warning:
When installing or replacing the Mitel GX Gateway, the earth ground connection
between the grounding screw on the back of the Mitel GX Gateway and an appropriate grounding
point in your site must always be made first and disconnected last. This is mandatory to avoid any
damage or injuries, even if the Mitel GX Gateway is installed in a grounded equipment rack.
Warning:
The earth ground cable should be the same size (18 AWG minimum) as the earth cable
of the provided power cord. Otherwise, make sure the earth ground cable meets the standards
and requirements of your local electrical code. The type of the cable is likely to have VW-1 or RT1
markings on the cable.
Warning:
The earth ground cable must be firmly and securely connected to the grounding screw
on the back of the Mitel GX Gateway and an appropriate grounding point in your site: the earth
ground cable must remain tightly secured at all times during service and installation.
Warning:
Before performing this procedure, you must first read and understand the Safety
Recommendations listed in this document.
Note:
Note or take a picture of your unit's serial number before starting the installation, and place the
card stickers of the cards not factory installed. Refer to
Steps
1)
Install the unit on a flat surface or in an equipment rack. Refer to
(p.19).
Surface
Caution:
the environment next to the Mitel unit may become greater than the maximum operating temperature
recommended by Mitel for the use of its units, i.e. 40ºC. The Mitel GX Gateway should never be used to
temperatures greater than the recommended maximum operating temperature. Any damage occurring
in such environmental conditions will void the warranty.
2)
Connect the Telephony Interface Cables. Refer to
Caution:
location on the Mitel GX Gateway.
3)
Connect the Ethernet Cables. Refer to:
a)
Connecting the Mitel GX Gateway Using a DHCP Server
b)
Connecting the Mitel GX Gateway Using a Static IP Address
GX Gateway Hardware Installation Guide
If the unit is installed in a closed environment or on a multi-unit rack, the ambient temperature of
To prevent damage to the Mitel GX Gateway, make sure to connect the cables to their proper
Locating the Product Serial Number
Installing the Unit on a Flat
Connecting the Telephony Cables
(p.20)
(p.21)
18
(p.26).
(p.19).
Advertisement
Table of Contents
Troubleshooting
