Reset/Default Button - Mitel Mediatrix Model M Hardware Installation Manual

LED state
Power LED blinking green 3 cycles per second,
50% duty.
Ready LED OFF, all other LEDs cycling from
right to left, left to right.

RESET/DEFAULT Button

The Reset/Default button is a switch that can be used to perform a partial or factory reset while the unit
is running.
In other words, the Reset/Default button can be used to:
• Cancel an action that was started.
• Revert to known factory settings if the Mitel GX Gateway refuses to work properly for any reason
or the connection to the network is lost.
• Reconfigure a unit.
The Reset/Default button will generate different actions depending on the amount of time the button is
held.
IMPORTANT: It is the LED pattern that will indicate the action that is being applied to the unit. The
action will occur more or less rapidly depending on the platform.
LED Pattern
Power1 blinking, all other LEDs
OFF
All LEDs blinking, 1cycle per
second, 50% duty
All LEDs steady ON
GX Gateway Hardware Installation Guide
Description
Waiting for DHCP (IPv4 or IPv6) answer or IPv6
router advertisement or PPPoE connection. No Ip
Address configured.
The unit tries to download and install a firmware
given by the Network Rescue server.
Action
Restarts the Mitel GX Gateway.
Initiates a Partial Reset of the
Mitel GX Gateway.
Note: The
optional as it can be disabled
with the
Hardware.ResetButtonManagement
parameter. For more details, refer
to the
DGW Configuration Guide -
Reference Guide
Media5 documentation portal at
https://
documentation.media5corp.com/
Initiates a Factory Reset of the
Mitel GX Gateway.
Comment
No changes are made to the
Mitel GX Gateway settings.
Restarts the unit in a known and
static state while keeping most
of the configuration unchanged.
partial reset is
CLI
published on the
Reverts the unit back to its
default factory settings.
28