Factory Reset
The Factory reset reverts the Mitel GX Gateway back to its default factory settings.
It deletes the persistent configuration parameters of the unit, including:
•
User files stored in the File service
•
Certificates, except for factory installed ones
•
Log files of the File service
The Factory reset should be performed with the Mitel GX Gateway connected to a network with access
to a DHCP server. If the unit cannot find a DHCP server, it will sent requests indefinitely. A Factory Reset
can be triggered either:
•
Directly on the unit. Refer to
•
Via the web interface of the Mitel GX Gateway (Management/Firmware Upgrade).
•
Via the Command Line Interface of the Mitel GX Gateway by using the fpu.defaultsetting
parameter.
Performing a Factory Reset
Information
The Factory reset alters any persistent configuration data of the Mitel GX Gateway.
Steps
1)
Insert a small, unbent paper clip into the hole of the Reset/Default button, located on the Mitel
GX Gateway.
Do not release the
Note:
This can last from 12 to 16 seconds. If you leave the inserted pin longer, no action will be taken
which is useful if you accidentally pushed the button and do not need any action to be applied.
2)
Release the paper clip.
Result
All configuration parameters are reset to their default value. The unit can then be contacted via its WAN
interface DHCP-provided IP address (ETH1), or via its LAN interface default IP address 192.168.0.10
(ETH2-5).
GX Gateway Hardware Installation Guide
Performing a Factory Reset
button before the LEDs stop blinking and are steadily ON.
Reset/Default
(p.33).
32