Mitel Mediatrix Model M Hardware Installation Manual page 16

# LED
13 ETH2/3/4/5/-Right LED
(activity)
13 ETH2/3/4/5/ -Left LED
(speed)
16 LED
Switches
# Switch
4 Reset/Default
Connectors and cards
# Connectors/
cards
5 USB
6 SYNC IN
7 SYNC OUT
10 PRI card with PRI
port
12 ETH1
13 ETH2-ETH3-
ETH4/ ETH5
14 FXS card with 4
FXS ports
15 FXO card with 4
FXO ports
GX Gateway Hardware Installation Guide
Behavior
Green blinking, variable rate
Green, steady ON
OFF
OFF
Green
Yellow
Green, steady ON
OFF
Description
Allows setting the unit to default (known) values. Refer to
(p.28)
Button
Description
USB connector
8 KHz TDM synchronisation pulse input
8 KHz TDM synchronisation pulse output
RJ-48 connector for ISDN-PRI connectivity
A 10/100/1000 BaseT Ethernet RJ-45 connector for access to a LAN,
WAN, or computer. This port is by default used for uplink / WAN
connection.
10/100/1000 BaseT Ethernet RJ-45 connector for access to a LAN,
WAN or computer. These ports are used by default for LAN
connections.
RJ-11 connector for phone/fax/PBX-FXS connection
RJ-11 connector for PSTN/PBX-FXS connection
Condition
Network traffic
No network traffic
Not connected
10 Mbps
100 Mbps
1000 Mbps
Indicates that the BRI port is
well connected/configured
and the link is up.
Indicates that the BRI port is
not well connected or
configured, and that the link
is down.
RESET/ DEFAULT
16