Adjusting The Machine Software; Preparing The Machine - Toro Groundsmaster 4300-D Operator's Manual

9
Adjusting the Machine
Software
No Parts Required
Procedure
Contact your authorized Toro distributor to set the
machine software to the CE mode.
10

Preparing the Machine

No Parts Required
Checking the Tire Pressure
Check the tire pressure before use; refer to
the Tire Pressure (page
Important:
Maintain pressure in all tires to
ensure a good quality-of-cut and proper machine
performance. Do not underinflate the tires.
Checking the Fluid Levels
1. Check the engine-oil level before starting the
engine; refer to Checking the Engine-Oil Level
(page 56).
2. Check the hydraulic-fluid level before starting
the engine; refer to
Level (page 66).
3. Check the cooling system before starting the
engine; refer to Checking the Cooling System
(page 63).
Greasing the Machine
Grease the machine before use; refer to
Bearings and Bushings (page
grease the machine results in premature failure of
critical parts.
Checking
28).
Checking the Hydraulic-Fluid
Greasing the
53). Failure to properly
16