Pre-Maintenance
Procedures
Raising the Machine
Use the following as points to jack up the machine:
•
Front of the machine—rectangular pad, under
the axle tube, inside each front tire
Figure 64
1. Front jacking point
•
Rear of the machine—rectangular axle tube on
the rear axle.
Lubrication
Greasing the Bearings and
Bushings
If you operate the machine under normal conditions,
use No. 2 lithium grease to lubricate all bearings
and bushings at the specified maintenance interval.
(Figure
64).
Lubricate bearings and bushings immediately after
every washing, regardless of the interval listed.
The grease fitting locations and quantities are as
follows:
•
Pump driveshaft U-joint
g031850
•
Cutting unit lift-arm cylinders (2
•
Lift-arm pivots (1
53
(3)—Figure 65
Figure 65
each)—Figure 66
Figure 66
each)—Figure 66
g003962
g011612