Product Overview; Controls - Toro Groundsmaster 4300-D Operator's Manual

Product Overview

Controls

Traction Pedal
The traction pedal (Figure
reverse operation. Press the top of the pedal to move
forward and the bottom to move rearward. Ground
speed depends on how far you press the pedal. For
no load, maximum ground speed, fully press the pedal
while the throttle is in the F
To stop, reduce foot pressure on the traction pedal
and allow it to return to the center position.
Mow-Speed Limiter
When the mow-speed limiter
will control the mow speed and allow the cutting decks
to be engaged. Each spacer adjusts the mowing
speed by 0.8 km/h (0.5 mph). The more spacers
you have on the top of the bolt, the slower you will
go. For transport, flip back the mow speed limiter for
maximum-transport speed.
11) controls the forward and
position.
AST
(Figure 11) is flipped up it
Brake Pedal
Press the brake pedal
Parking Brake
To engage the parking brake,
the brake pedal and press the top forward to latch. To
disengage the parking brake, press the brake pedal
until the parking-brake latch retracts.
1. Traction pedal
2. Mow-speed limiter
3. Spacers
Tilt-Steering Pedal
To tilt the steering wheel toward you, press the foot
pedal down, pull the steering tower toward you to
the most comfortable position, and release the pedal
(Figure 11). To move the steering wheel away from
you, press the foot pedal and release it when the
steering wheel reaches the desired operating position.
Headlight Switch
Pivot the switch downward to turn on the headlights
(Figure 12).
Engine-Speed Switch
The engine-speed switch
change the engine speed. Tap the switch to increase
or decrease the engine speed in 100 rpm increments.
Hold the switch down to automatically move the
engine to High or Low idle, depending on which end
of the switch that you press.
17
(Figure 11) to stop the machine.
(Figure 11) push down
Figure 11
4. Brake pedal
5. Parking brake
6. Tilt-steering pedal
(Figure 12) has 2 modes to
g003955