Pattfield Ergo Tools k600-1 BS Original Instructions Manual page 239

Problem
3. Engine overheats
4. Engine operates erratically 4.1.
5. Unsatisfactory result
6. Roller brush does not
sweep
7. Excessive vibration/noise
or exhaust
MNL_DFT_k600-1 BS_V02_130708.indb 239
Possible cause
3.1. Oil level low
3.2. Air filter dirty
3.3. Air vents blocked
3.4. Improper carburettor
adjustment
Improper carburettor
adjustment
4.2. Spark plug connector
loose
4.3. Air filter dirty
4.4. Not enough fuel in fuel
tank
4.5. Blocked fuel pipe
4.6. Air vents blocked
5.1. Roller brush damaged
or bent
5.2. Roller brush worn
5.3. Improper wire
adjustment
5.4. Tires worn
5.5. V-belt slack or worn
6.1. Roller brush blocked
6.2. Roller brush control
lever is loosen or wire
is worn
6.3. V-belt slack or worn
7.1. Roller brush is
damaged
7.2. Screws/nuts are loose
7.3. Fuel is incorrect
Solution
3.1. Add oil
3.2. Clean air filter
3.3. Remove blockade
3.4. Adjust carburettor
4.1. Adjust carburettor
4.2. Attach properly
4.3. Clean air filter
4.4. Add fuel
4.5. Clean fuel pipe
4.6. Remove blockade
5.1. Have it replaced
5.2. Adjust castor height
or have roller brush
replaced
5.3. Adjust wires
5.4. Have them replaced
5.5. Have it replaced
6.1. Remove blockage
6.2. Tighten loosen
lever, replace worn
wire
6.3. Have it replaced
7.1. Have it replaced
7.2. Tighten the screws/
nuts
7.3. Empty out unused
fuel and refill with
correct fuel
GB
239
7/8/13 5:04 PM