Pattfield Ergo Tools k600-1 BS Original Instructions Manual page 223

j). Start the engine carefully according
to instructions and with feet well away
from the tool(s).
k). Do not put hands or feet near or under
rotating parts.
l). Never pick up or carry a product while
the engine is running.
m). Stop the engine and disconnect the
spark plug connector, make sure that all
moving parts have come to a complete
stop and, where a key is fitted remove
the key:
- before clearing blockages
- before checking, cleaning or working
on the product,
- after striking a foreign object.
Inspect the product for damage and
make repairs before restarting and
operating the product,
- if the product starts to vibrate
abnormally (check immediately),
- being transported by means other
than under its own power,
- whenever you leave the product,
- before refuelling.
n). Reduce the throttle setting during
engine shut down and, if the engine is
provided with a shut-off valve, turn the
fuel off at the conclusion of working.
o). Never touch the exhaust, exhaust guard
or cooling fins when the engine is hot.
p). Never carelessly touch the product, you
can burn yourself. While the product
is in operation or shortly thereafter, its
parts such as the exhaust pipe, engine,
and other surfaces are extremely hot!
Pay attention to the markings on the
product.
q). Make sure that the air intake of the
combustion engine is clear. Keep the
air intake free of dust, dirt particles,
gases and fumes. Keep hands and feet
away from the rotating tool at all times
and especially when switching on the
engine.
MNL_DFT_k600-1 BS_V02_130708.indb 223
Maintenance and storage
a). Follow the maintenance and repair
instructions for this product. Never carry
out any modifications of the product.
Never change the pre-set rotary speed
or the engine and product settings.
Information about maintenance and
repair is provided in this user manual.
b). Keep all nuts, bolts and screws tight to
be sure the product is in safe working
condition.
c). Never store the product with petrol in
the tank inside a building where fumes
can reach an open flame or spark.
d). Allow the engine to cool before storing
in any enclosure.
e). To reduce the fire hazard, keep the
engine, silencer, battery compartment
and petrol storage area free of
vegetative material and excessive
grease.
f). Replace worn or damaged parts for
safety.
g). If the fuel tank has to be drained, this
should be done outdoors.
h). Always replace worn or faulty parts with
the genuine parts.
2 Fuel handling
a). Always switch the product off and let it
cool down, before refuelling it. Petrol is
highly flammable. Never smoke when
you are refuelling the product. Do not
refuel the product, if there is an open
fire in the vicinity!
b). Always use suitable aids such as
funnels and filler necks. Do not spill
any fuel on the product or its exhaust
system. There is a risk of ignition.
However, if fuel should be spilled, then
you must remove it carefully from all
parts of the product. Any residue which
may be present must be completely
removed, before the product is
operated!
GB GB
223
7/8/13 5:04 PM