Pattfield Ergo Tools k600-1 BS Original Instructions Manual page 235

WARNING! If the wheels or the
roller brush show any signs of
rotating stop the engine! Wait for
all moving parts to stop! Contact
a qualified specialist to re-adjust
the wires!
13 Sweeping
a). Adjust the sweeping direction by turning
the locking handle bar as described
above.
b). Slowly push the product forward.
Use the self-propelled function for
assistance.
c). Pay attention to the wind direction.
Sweeping with the wind makes it more
effective and helps to keep debris off
the operator.
d). Sweep in slight overlapping rows. The
most effective pattern for sweeping is
straight lines along one of the sides.
This will ensure not to miss any spots
(Fig. 29).
e). Pay special attention when changing
direction.
f). Pay attention
14 Clearing snow
WARNING! Ensure that no
hidden objects are covered by
the snow! Remove all foreign
objects from the area to be
cleared before operating the
product!
a). Adjust the snow blade as described
above.
b). Perform a thorough inspection of the
area since some objects may be hidden
from view by surrounding snow. If the
product hits an obstruction, stop the
product and switch it off. Inspect the
product for damage. Repair or replace
any damaged part before restarting and
operating the product.
MNL_DFT_k600-1 BS_V02_130708.indb 235
c). Adjust the clearing direction by turning
the locking handle bar as described
above.
d). Slowly push the product forward.
Use the self- propelled function for
assistance.
e). Pay attention to the wind direction.
Clearing with the wind makes it more
effective and helps to keep snow off the
operator.
f). Clear the snow in slight overlapping
rows. The most effective pattern for
clearing snow is straight lines along one
of the sides. This will ensure not to miss
any spots (Fig. 30).
g). Pay special attention when changing
direction.
h). Some parts of the product may freeze
under extreme temperature conditions.
Do not attempt to operate the product
with frozen parts. If the parts freeze
while the product is in use, stop the
product, switch it off and inspect for
frozen parts. Free all parts before
restarting or operating the product.
Never force controls that are frozen
15 After use
a). Switch the product off as described
above, disconnect the spark plug
connector (24) and let it cool down.
b). Check, clean and store the product as
described below.
GB
235
7/8/13 5:04 PM