Pattfield Ergo Tools k600-1 BS Original Instructions Manual page 230

2 Handle bars
a). Loosen the pre-assembled knobs (7a)
and remove them with the spacers (7b),
outer discs (7c) and bolts (7e) from the
lower handle bar (6). Leave the inner
disc (7d) on the lower handle bar
(Fig. 1).
b). Align the holes in the outer disc (7c)
with the ones in the upper handle
bar (2). Pay attention to the correct
alignment of the outer disc. Attach the
outer disc to the upper handle bar
(Fig. 2).
c). Guide the upper handle bar (2) to the
lower handle bar (6). Carefully place the
outer disc (7c) on the inner disc (7d).
d). Align the holes. Insert the bolt (7e) and
secure the upper handle bar (2) with
the spacers (7b) and knobs (7a) to the
lower handle bar (6). Lightly tighten the
knobs. (Fig. 3).
GB
e). Raise the upper handle bar (2) to the
desired position. Ensure that the teeth
of the discs (7c, 7d) interlock. Tighten
the knobs (7a) (Fig. 4).
f). Fix the wires (5, 12, 14) with the wire
clips (4) to the handle bars (2, 6)
(Fig. 5).
3 Locking handle bar
a). Remove the bolt (11c) and the nut (11d)
from the bracket (11b).
b). Insert the locking handle bar (11) in the
bracket (11b). Align the holes with each
other (Fig. 6).
c). Secure the locking handle bar (11) with
the bolt (11c) and nut (11d). Use proper
wrenches (Fig. 6).
4 Snow blade (optional)
a). Remove the pre-assembled bolts (28a)
and nuts (28b) from the support (28).
b). Secure the support (28) with the
bolts (28a) and nuts (28b) to the snow
blade (26). Use proper wrenches
(Fig. 7).
230
MNL_DFT_k600-1 BS_V02_130708.indb 230
c). Remove the bolts (27a) and nuts (27b)
from the locking rods (27).
d). Insert the locking rod (27) into the upper
mounting hole (9a) of the
guard (9). Insert the bolt (27a) into the
lower mounting hole (9b). Secure the
locking rod with the nut (27b) to the
guard (9) (Fig. 8).
e). Repeat the above mentioned steps for
the remaining locking rod.
Attach
a). Align the mounting holes of the snow
blade (26) with the locking rods (27).
Attach the snow blade and insert the
R-clips (27c) into the holes of the
locking rods to secure the snow blade
(Fig. 9).
b). Ensure there is a gap between the
lower edge of the snow blade and the
ground. Adjust the height of the castors
if required (see section "Castors and
roller brush").
Remove
a). Remove the R-clips (27c) from the
locking rods (27).
b). Remove the snow blade (26).
5 Fuel and engine oil
This product is equipped with a 4-stroke
engine. Before operation it is necessary to
add proper fuel and engine oil.
WARNING! This product
contains an instruction manual
of the engine. It is important
to read and understand these
instructions of the engine and the
equipment.
SAVE THESE ORIGINAL
INSTRUCTIONS FOR FUTURE
REFERENCE.
a). Place the product on a stable, level
surface. We recommend laying a non-
flammable sheet underneath.
7/8/13 5:04 PM