Moni Key Function; Edit Channel - Alinco DJ-CRX7 Instruction Manual

BASIC OPERATIONS
2. CALL: Assign this function to transmit the prestored DTMF Encode signal in channel. By other
combination key, press and hold [PTT] then press [MONI] key to transmit DTMF code.
3. ALARM: Assign this function to enable the ALARM function. Under standby state,
press and hold [PF1] or [PF2] key which is programmed with ALARM function until
LCD displays "ALARM", Emergency alarm function is started. This transceiver has
3 Alarm modes for optional, can be setup in programming software. Press and hold
the key or power off to exit alarm.
4. Transmit tone burst frequency: Press and hold [PTT] key, then press [PF1]/[PF2] key to transmit
selected tone burst frequency. The tone burst frequency can be set to 1000Hz / 1450Hz/1750Hz / 2100Hz.

MONI Key Function

Following functions can be assigned to the [MONI] key.
1. Squelch off: Press [MONI] key, you can hear background noise. Press [MONI] again, squelch is mute.
2. Monitor: Press and hold [MONI] key, you can hear background noise. Release [MONI], squelch is mute.
3. [MONI] key is also used to activate the function set mode, refer to P.46 for more detail.

Edit Channel

To store a frequency to a channel follow the below steps.
1. Under frequency mode (VFO), enter desired frequency, press
" " icon, press key to switch into channel mode, channel number flashes.
key, the top corner of LCD displays
14