Start/Stop Button; Digital Display; Rate Selection Button; Led Indicators - Motomaster ELIMINATOR WORKSHOP 011-1978-2 Instruction Manual

START/STOP BUTTON

Press to immediately begin charging your properly
connected battery. If the button is not pressed,
charging should begin automatically in 30 seconds.

DIGITAL DISPLAY

The Digital Display gives a digital indication of
voltage, % of charge, or alternator status. If you
manually start or stop the charging process (by
pressing the Start/Stop button), the display will
show ON or OFF respectively for a few seconds
before displaying the battery voltage.
DISPLAY MODE BUTTON
Battery % – The digital display shows an
estimated charge percentage of the battery
connected to the charger's battery clamps.
Alternator % (12 V only) – The digital display
shows an estimated output percentage of the
vehicle's charging system connected to the
charger's battery clamps, compared to a properly
functioning system. The alternator percent range
is from 0% to 100%. Readings below 0%
(13.2 V) will read LO and readings above 100%
(14.6 V) will read HI. If you get a HI or LO reading,
have the electrical system checked by a qualified
technician.
Voltage – The Digital Display shows the voltage at
the charger battery clamps, in DC volts.

RATE SELECTION BUTTON

Use this button to select one of the following:
• 3 A – For charging small batteries, such as
those commonly used in garden tractors,
snowmobiles and motorcycles. Also used to
maintain fully charged large batteries.
• 15 A – For charging automotive, marine and
light truck batteries. Not intended for industrial
applications.

LED INDICATORS

• Charging (yellow) LED lit:
The charger is charging the battery.
• Charged/Maintaining (green) LED lit:
The battery is fully charged and the charger is
in maintain mode.
• Red LED solid: The connections are
reversed.
• Red LED blinking: The charger has detected
a problem with the battery.
See the Troubleshooting section for more
information.
9
®
MD